Power Supply is electical devices inside the computer. Power supply is usually placed in position behind the computer and have a fan for cooling the components inside.

Here are the steps for installing the ATX power supply in desktop computer:

Open the side cover chassis, (Case) by twisting the screws and slide the back cover of the rear chassis, or up depending on your case

Put the resources into its location, located behind the barrel machine. Note the correct way and set the position of the screw hole started, the fan facing the outside.

Getting four screws to locate the source and barrel machine.

Plug the supplied power cord into the correct position of the devices inside the Mainboard and the drive.

Cover cover chassis, Left side by sliding from behind the front, note the slots, grooves, … between cover and tank machine. Start the vit to locate the cover.

Plug the power cord into the back slot.

Note: You can use the wire pins plastic columns compact power cords too long, not to touch the wire of the CPU fan. If you turn on the switch that the machine has no power to check the plug wires inside, a source of electricity 110V/220V switch and adjust the switch On / Off is back.